ILME: APX Gehäuse aus Aluminiumdruckguss - APV ATEX

2 Product features Distribution boxes made of EN AB 46100 aluminium alloy (previously UNI 5076) in accordance with standards UNI EN 1676 and oven painted with RAL 7040 epoxy-polyester resins Supplied with: - Cover with pre-fastened gasket - AISI 304 stainless steel screws to fix the cover in place - O-ring in nitrile rubber to hold the cover screws in place (captive screws) - 1 internal equipotential bonding kit (for example between the box and the cover), which includes 1 M4x8 threaded brass insert, 1 M4x8 zinc-plated steel screw, 1 ring lug in tinned copper for a cross-sectional area up to 6 mm 2 - 1 external equipotential bonding kit (1 M4x8mm stainless steel self-forming screw + 1 lug in tinned copper for a cross-sectional area up to 6 mm 2 ) - Installation, operation and maintenance instructions, EC declaration of conformity The inside of the boxes contains supports for grounding and for the application of the bottom plates, supports and other accessories. The hole on the outside can be used for the equipotential bonding connection. Wall-mounting is possible thanks to the external brackets built into the base. Every box is packaged individually. Kits for internal fixings (bottom plates, DIN EN 60715 rails) are available on request (see the applicable catalogue page). ATTENTION! APX containing boxes are sold empty. According to the ATEX Directive, they are regarded as electric material therefore classified as Ex components. They can be used in combination with other electrical equipment in which case the end user must obtain a further ATEX certification in addition to the one supplied by I.L.M.E. SpA In addition to the markings required to certify compliance with product standards CEI EN 60670-1 and CEI EN 60670-22 (IP66/IP67 protection degree, trademark) and with the e marking that confirms compliance with the Low Voltage Directive 2006/95/EC, each box has a nameplate on the cover that lists the markings required by the latest editions of applicable ATEX standards (CEI EN 60079-0, CEI EN 60079-15 and CEI EN 60079-31) that integrate those required by the ATEX Directive. NOTE – The new edition of standard CEI EN 60079-0 groups, for the first time, all ATEX safety requirements concerning gases and dust, therefore replaces previous CEI EN 61241-0 standards. The new CEI EN 60079-31:2009 standard replaces standard CEI EN 61241-1. Marking requirements have been further changed, so for a certain period of time three different markings that are substantially equivalent may be found simultaneously on the market.